(5) Support Removal
The PrinterTool software includes different types, sizes and shapes of supports. Supports can be easily removed
by hand, otherwise, use pliers or knives remove smaller or more delicate areas.
(6) Casting Preparation
Sprue the model to the casting tree. The support structures must not be used for spruing due to it's dimensional ratio.
For best results, you may remove supports before curing the pieces.
The sprue diameter must be at least 50% larger than the thickest/heaviest section of
the model. It should be attached directly to this section if the design permits.
26
4. After Printing is Complete (continued)
4.1 Casting Preparation and Burn-Out process
with Tiger3D Burgundy Castable Resin
Explore Endless Creativity with Tiger 3D
To Next Page
Loading...