Tiger 3D Printers Tiger3D XHD - Casting Preparation and Burn-Out Process; After Printing Is Complete

(3) Drying
Usingcompressedair,drythemodeltoamattenishlook.Thiswillnormallytakea1-2minutes.
(4) Curing
Place the model inside the post curing UV lamp unit.
Depending on the model’s geometry, it may take up to
30-45 minutes to cure.
(4.2) Curing
Immerse the model completely in water in a transparent
container. Cure for an additional 60 minutes.
If the surface of the model appears too shiny after cleaning, additional time in the
denatured alcohol soak may be needed.
After curing, the surface of the model should not feel sticky. The build base may
shrink a bit but this will not affect the quality of the model.
25
4. After Printing is Complete (continued)
4.1 Casting Preparation and Burn-Out process
with Tiger3D Burgundy Castable Resin
Explore Endless Creativity with Tiger 3D