Tiger 3D Printers Tiger3D XHD - Cleaning Picker and Tank

4.2. Cleaning Picker and Tank
(1) Cleaning Picker
27
Use a putty knife or similar object to scrape
away the excess printed model resin from the
picker. If any greasy residue persists, use a
soft cloth dipped in alcohol to rub and clean
the surface until the grease is removed.
(1) Using the plastic scraper, scrape the entire
surface of the material tank clean.
NOTE: Do not remove the tank for this
procedure
NOTE: Do not ll exceed the top line, when
relling otherwise the resin will spill over
when printing.
(2) Cleaning Resin Tank
NOTE :
- Do not shut down the power during printing
- Do not interrupt the rmware upgrade process. Any interruptions during the rmware upgrade may
cause your printer to malfunction.
- Update the rmware frequently for a better user experience
Explore Endless Creativity with Tiger 3D