Tinius Olsen MP1200 Extrusion Plastometer Page 5-6
Operation Manual # 02002215
NOTE: The update installs the following Sample Programs.
TEST 1 FOR GENERIC PE
TEST 2 FOR GENERIC PP
TEST 3 SAMPLE MVR
TEST 4 SAMPLE PROC A
TEST 5 SAMPLE MELT DENSITY CALC
TEST 6 SAMPLE TIME BASED
TEST 7 SAMPLE ISO PROC A
If you happen to have a test program named the same as any of the above, it will be
overwritten. You may want to save your program under a different name.
5.5.7 Plug the USB drive into the MP1200 and turn on the power. There will be a popup
box prompting to upgrade the firmware. Select ‘Yes’ before the progress bar
finishes. No further interaction is required. The MP1200 will then proceed to update
controller and display firmware. There will be several pop-up windows and status
messages. Once finished it will start up the MP1200 and the USB drive can be
removed.
If you have any questions or concerns, please contact helpdesk@tiniusolsen.com.
To Next Page
Loading...
