Tinius Olsen MP1200 - Page 70

Tinius Olsen MP1200 Extrusion Plastometer Page 13-2
Operation Manual # 02002215
TEST # 5 Melt Density Calc
TEST # 6 Sample Time Based
TEST #7 ISO 1133 Proc A
Auto Timed Flow
Auto Timed Flow
Manual Cut
Units
mm
Units
mm
Units
mm
Set Point
190.0
Set Point
190.0
Set Point
190.0
Load
2.16
Load
2.16
Load
2.16
Orifice Diameter
2.096 mm (0.0825 in.)
Orifice Diameter
2.096 mm (0.0825 in.)
Orifice Diameter
2.096 mm (0.0825 in.)
Orifice Length
8.001 mm (0.315 in.)
Orifice Length
8.001 mm (0.315 in.)
Orifice Length
8.001 mm (0.315 in.)
Preheat Time
390
Preheat Time
390
Preheat Time
300
Melt Density
Calculated
Melt Density
Entered
No of Cuts
4
Melt Density Value
NONE
Melt Density Value
0.7636
Cutoff Interval
60
Enable Auto Cut
OFF
Enable Auto Cut
OFF
Enable Auto Cut
OFF
No of Captures
1
No of Captures
1
Standard Identifiers
Sample ID
Start Height #1
46.00 mm (1.811 in.)
Start Height #1
46.00 mm (1.811 in.)
Standard Identifiers
Operator
Piston Travel Cap 1
25.4
Travel Time
360
Standard Identifiers
Test Method
Enable WLD
ON
Enable WLD
OFF
Test Results
Time
WLD Height
52
WLD Height
None
Test Results
Cut-Off Time
Time Limit
OFF
Time Limit
OFF
Test Results
MFR g/10 min
Time Limit Value
0
Time Limit Value
0
Test Results
Capture Weight
Standard Identifiers
Sample ID
Standard Identifiers
Sample ID
Alarm:
At End of Preheat
Standard Identifiers
Operator
Standard Identifiers
Operator
Alarms
Capture Start
Standard Identifiers
Test Method
Standard Identifiers
Test Method
Alarms
Capture End
Test Results
Total Preheat
Test Results
Total Preheat
Test Results
MFR g/10 min
Test Results
MFR g/10 min
Test Results
Melt Density
Test Results
Melt Density
Alarm:
At End of Preheat
Alarm:
At End of Preheat
Alarms
Capture Start
Alarms
Capture Start
Alarms
Capture End
Alarms
Capture End