1200-1600 Series Rotary Cutters 18 Titan Implement, LLC
August 2016 (423) 334-0012
3. SAFETY SIGNS AND INSTRUCTIONAL LABELS
3.1 General Information
The types of safety signs (hazard labels) and
instructional labels, along with their locations on the
equipment, are shown in the following illustrations.
Good safety practices require that you familiarize
yourself with the various safety signs, the type of
warning, and the area or particular operation related to
that area that requires your SAFETY AWARENESS.
THINK
SAFETY!
Think SAFETY!
Work SAFELY!
Pay close attention to the safety signs and instructional
labels attached to the tractor and the rotary cutter.
Duplicate safety signs, which are attached to the rotary
cutter, can also be found in this section. If the rotary
cutter is missing a label or one is unreadable, replace
the label before using the rotary cutter.
SAFETY
INSTRUCTIONS
N
I
NG
AR
Safety Signs and Instructional Labels
1. Keep safety signs or instructional labels clean
and legible at all times. Use a clean, damp cloth
to clean safety decals.
2. Replace any missing or hard-to-read safety signs
or instructional labels.
3. Use care when washing or cleaning the equipment
not to remove or damage the labels. When using
a pressure washer to clean the rotary cutter, avoid
spraying too close to decals; high-pressure water
can enter through very small scratches or under
edges of decals causing them to peel or come off .
4. Locations for the labels and replacement part
numbers are shown in this section.
5. Replacement parts must have replacement labels
attached during installation and/or before the
rotary cutter is used.
6. Labels are available from your authorized dealer
or from Titan Implement at no charge.
3.2 How to Install Replacement Safety Signs
1. Clean and dry the installation area.
Note: Do not install the signs if the temperature is
below 50°F (10°C).
2. Determine the exact position before you remove the
backing paper.
3. Remove the backing paper.
4. Align the sign over the specifi ed area and carefully
press the sign to the part/frame.
Note: Small air pockets can be pierced with a pin and
smoothed out using the piece of backing paper.
To Next Page
Loading...
