Titan Implement, LLC 45 1200-1600 Series Rotary Cutters
(423) 334-0012 August 2016
9.13 Service Record
The period recommended is based on normal
operating conditions. Severe or unusual conditions
may require more frequent lubrication or oil changes.
Copy this page to continue record.
Hours and
Serviced By
Maintenance
Every 8 Hours
Make sure blade bolts are tightened to proper torque.
Make sure all retainer clips and cotter pins are in place.
Inspect the cutting blades for wear and damage.
Grease the driveline U-joints and slip joint.
Every 50 Hours
Check blade pan nut torque.
Grease all lubrication points.
Annually
Grease all lubrication points.
Make sure all fasteners are properly tightened.
Check cutter deck, gearbox, and driveline for damage.
Inspect the cutting blades for wear and damage.
Make sure the 3-point hitch pins and retainer clips are in
good condition. Do not use homemade or shop-made
pins.
If equipped, make sure the slip clutch is functioning
properly.
Inspect the hitch A-frame and braces for wear and
damage.
Wash the rotary cutter.
To Next Page
Loading...
