Titan Implement, LLC 47 1200-1600 Series Rotary Cutters
(423) 334-0012 August 2016
Gearbox leaking. Damaged oil seal. Replace seal.
Bent shaft. Replace gearbox.
Oil seal not sealing in the housing. Replace seal or use a sealant on O.D.
of seal.
Oil level too high. Drain to proper level.
Gasket damaged. Replace gasket.
Bolts loose. Tighten bolts.
Gearbox overheating. Low on lubricant. Fill to level plug.
Improper type of lubricant. Replace with proper lubricant. Refer to “9.3
Driveline Lubrication” on page 42.
Excessive trash build-up around gearbox. Remove trash.
Shear pin shears excessively. Tractor PTO not being run at 540 RPM. Maintain 540 RPM PTO speed.
Heavy material. Reduce ground speed. Raise cutting height.
Not using proper bolt. Replace only with recommended shear bolt.
Refer to “9.8 Shear Bolt Replacement (If
Equipped)” on page 43.
PTO engaged at high engine RPM. Engage PTO at low engine RPM.
Cutting in rocky conditions. Increase cutting height.
Blade carrier RPM too high. Maintain 540 RPM PTO speed.
Excessive vibration. Blades are not free to swing. Check bushing and blade movement.
Blades are out of balance. Check blades for damage or replace blades.
Refer to “9.5 Blade Servicing” on page 42.
Unusual noise. Loose blade bolts or worn bushings. Tighten bolts, check bushings for wear and
change as needed. Refer to “9.5 Blade
Servicing” on page 42.
Bent blade carrier, blades. Replace blade carrier. Refer to “9.6 Blade
Carrier Removal” on page 43.
Deck bent, causing blades to contact deck. Straighten deck.
Driveline will not telescope. Improper lubrication. Grease driveline. Refer to “9.3 Driveline
Lubrication” on page 42.
Driveline twisted. Replace driveline. Caution operator not to
strike ground with blades.
Driveline bent. Driveline too long. Replace and shorten to
proper length. Refer to “5.5 Shortening the
Driveline” on page 30.
Shields damaged. Replace shields.
Driveline twisted. Overtorqued. Do not allow blades to contact ground.
Not maintaining correct PTO speed. Maintain 540 RPM PTO speed.
To Next Page
Loading...
