Setting Up Your System
To set the system’s toll restric-
tion access code:
At Station #1
1:
1
Press PROGRAM.
- The display will read “Program...”
2 Press the soft key under NEXT
repeatedly, until “Toll Restriction”
appears in the display, and then
press ENTER.
- The display will read “Access
Code:
****
.”
3 Press the soft key under CHANGE if
you wish to store a new access
code.
4 Enter a 4 digit number.
5 Press PROGRAM to exit.
The Toll Restriction feature enables you to con-
trol outgoing calls and helps you prevent unau-
thorized long distance calls.
The toll restriction access code is set at station
#11. This code is needed when you wish to
change any toll restriction settings or when you
wish to turn toll restriction on or off at a particu-
lar phone. (See page 40).
If you ever forget the access code, simply set a
new code at Station #11. Until you set the
access code, the code will be the one set at the
factory, which is “1234”.
Setting the restricted numbers and
the allowed exceptions at a particu-
lar telephone:
Follow the instructions on the following three
pages for setting toll restrictions at particular
phones. After you set a phone’s toll restrictions,
the settings will not be erased, even in the event
of a power failure. So you do not need to worry
about ever having to re-enter the toll restriction
settings at any of the stations. If you ever do
wish to erase all the toll restriction settings
stored at a particular phone, follow the instruc-
tions on page 49.
Turning toll restriction on/off at a
particular telephone:
Follow the instructions on page 40 for turning
toll restriction on and off at a particular phone.
Note: After setting a station’s restrictions, its toll
restriction is automatically ON. In the future, you
may temporarily override its toll restriction or turn
its toll restriction off for a longer period without
affecting the settings stored in the telephone.
Setting Up Toll Restriction
14
To Next Page
Loading...
