Setting the Loop Voltage Detector
To set your telephone’s loop
voltage detector:
1
Press PROGRAM.
- The display will read “Program...”
2 Press the soft key under NEXT
repeatedly, until “Advanced Setting”
appears in the display, and then
press ENTER.
3 Press the soft key under NEXT
repeatedly, until “Loop Detect”
appears in the display, along with
the current setting.
4 Press the soft key under CHANGE
repeatedly, until the desired loop
detect setting is displayed.
The choices are:
Loop Detect: 48V (factory setting)
Loop Detect: 24V (24 volts)
Loop Detect: 12V
Loop Detect: OFF
5 Press PROGRAM to exit.
Additional Information
Your Epic telephone will light up its line status
indicators when a non-EPIC telephone such as a
fax machine, modem, or standard telephone is
using a line.
Note: If the line status indicators of your EPIC
telephones do not function properly, either failing
to light up when a standard telephone uses a
line, or staying lit even though no telephone is
using a line, then the loop voltage detector set-
ting needs to be adjusted.
The factory setting of 48 volts is appropriate for
most installations. If this is not suitable, try set-
ting your phone to 24 volts, and if that does not
work, then set it to 12 volts. You can also turn
this feature OFF if you prefer.
If a line indicator at your EPIC telephone stays lit
because there is no telephone line connected,
and you wish to turn it off, do not use this feature.
Instead refer to page 19 and set this unconnect-
ed line at this station to UNCONNECTED.
73
To Next Page
Loading...
General