Adjusting Flash Length
Additional Information
109
Your EPIC telephone is factory-set to have a
flash length of 700 milliseconds, which is appro-
priate for most environments. However, if your
installation requires a longer or shorter flash
length, you may change the length to 100 mil-
liseconds, 300 milliseconds, or 1 second.
1 Press PROGRAM.
- The display will read “Program...”
2 Press the soft key under NEXT
repeatedly, until “Advanced Setting”
appears in the display, and then press
ENTER.
3 Press the soft key under NEXT
repeatedly, until “Flash Length”
appears in the display, and then press
ENTER.
The display will show the currently set
flash length.
4 Press the soft key under CHANGE
repeatedly, until the desired flash
length is displayed.
The choices are:
Length:100ms (100 milliseconds)
Length:300ms
Length:700ms (factory setting)
Length:1 second
5 Press PROGRAM to exit.
To Next Page
Loading...
