Compact IP Codec User's Manual
58
Techno Mathematical Co., Ltd.
2140P
E-104 E104:LAN corrupted LAN cable not be
connected or
disconnected.
Connect the LAN cable. Goes out when LAN
cable is connected.
E-110 E110:Wrong PWD Password registered on
the encoder and
password set by the
decoder are different.
From the Setup menu,
set the passwords on the
encoder and decoder to be
the same.
LED lights for five
seconds then goes out.
Note that this is
treated as a warning by
the encoder, and as an
error by the decoder.
E-300 E300:Video rate Low Video rate cannot be set
correctly because the
transmission rate
setting is too low.
(Example: For a
transmission rate of 64
kbps, and audio rate of
32 kbps, and packet
header loss of 16 kbps,
video becomes 16 kbps.)
*Though this is a type of
parameter error,
ParameterErr is not
output when this error is
output.
Increase the overall
transmission rate.
Make audio Channel 0
(no output).
Make audio 16 kbps.
Make PacketSize bigger
(which increases latency).
LED lit for five seconds,
then goes out.
E-800 E800: Appli Down Application software is
down.
Contact TMC Support. Goes out when app is
restarted.
E-801 E801:WDT Det. Watchdog timer
operation.
Contact TMC Support. Goes out when device is
restarted.
To Next Page
Loading...
Need help?
General