20
8. Memory Viewer
This section explains about the Memory Viewer.
The name and numbers of selected memory cells are displayed. By recalling a memory cell you
can make additions to that cell or compare the content of memory cells.
- The memory cell number selected in the Memory list box is highlighted in bold letters.
- To recall a memory cell, click the desired memory cell number then click “Change”.
- To write to a memory cell, click the number of the memory cell in which you wish to store the
information then click “Store”.
- To perform memory comparison, click the number of the memory cell to compare and click
“Compare”. The display will then be switched temporarily to the selected preset memory number.
To compare the content of a memory with that before edit, click the number of the memory cell
highlighted in bold letters and click “Compare”. The previous status will be restored when you
once again click “Compare”.
- The Memory area can be switched between docked and floating indications.
Memory list
Change button
Store button
Compare button
To Next Page
Loading...
Need help?
General
