18
7. Unit Viewer
This section explains about the Unit Viewer.
The units are displayed in one column. It is possible to display up to 30 units.
There are two display modes. You can switch between them by clicking the tab at the bottom.
List display
It is possible to reduce size of the signal-processing image of the units and display up to 30 units.
The unit name, the number of inputs and outputs, the matrix settings, and the crossover
combination information will be displayed abbreviated. By clicking an already created unit, you
can scroll through a linked Flow Viewer.
In the list display, the unit can be copied onto an empty unit by the created unit drag & drop.