17
Changing the Crossover Slope
You can change the crossover slope of an already created unit. Select the unit whose crossover
slope you want to change in the Unit Viewer or Flow Viewer.
From the menu bar, select Unit
→ Change X-over → Slope... to display the Crossover Slope
window. Then make the settings as in the creation procedure.
Changing the name of the unit
Select the unit whose name you want to change in the Unit Viewer or Flow Viewer.
From the menu bar, select Unit
→ Names... to display the Change Name dialog box.
Saving a unit as a template
Select the unit you want to save as a template in the Unit Viewer or Flow Viewer.
From the menu bar, select Unit
→ Save as a Unit Template → Unit Template... to display the Save
File dialog box.
Saving the Crossover settings as a template
Select the Crossover box you want to save as a template in the Flow Viewer.
From the menu bar, select Unit
→ Save as a Unit Template → X-over Template... to display the
Save File dialog box.
To Next Page
Loading...
Need help?
General
