PRE-OPERATING PREPARATIONS32
6
Pre-mixing type
Add engine oil into fuel tank. The mixing
ratio of gasoline and oil is 50:1. Make sure
that gasoline and oil are mixed well. The
mixing ratio during break in is 25:1.
Mixing Ratio
ENOM01003-0
Engine oil – gasoline mixing
procedure
ENOW00937-1
z Do not use other than two stroke engine
oil with specified grade, or the engine
may be damaged.
z Do not use fuel prepared in other than
specified mixing ratio.
- Lack of engine oil can cause severe engine
problems such as piston seizure.
-Excess of engine oil can shorten spark
plug life, and/or cause increase of noxious
exhaust.
For engine oil and gasoline mixing ratio,
refer to the table.
When portable fuel tank is used for
operation of outboard motor(s):
1
Pour engine oil into fuel tank, and
then, gasoline.
2
Put cap on the tank, and close tightly.
3
Close air vent plug tightly.
ENOW00938-0
Loose cap or air vent plug can cause leak of
fuel.
4
Shake the tank to mix engine oil and
gasoline well.
For boat with built in fuel tank:
1
Prepare separate fuel container for
pre-mixing.
2
Pour engine oil into fuel container, and
then, gasoline.
Engine Oil : Gasoline
During break-in 25 : 1
After break-in 50 : 1
CAUTION
ENOF01708-0
10L
(10 :0.2)
(10 :0.4)
(25:0.5)
(25:1)
2L 25L 30L
0
0.2L
0.4L
0.5L
1.0L
25 : 1
50 : 1
Oil
Fuel by Oil Mixing (25:1, 50:1)
Gasoline
WARNING
ENOF01709-0
To Next Page
Loading...
