TOHATSU M40D2 - Auto Mixing Type

PRE-OPERATING PREPARATIONS 33
6
3 Put cap on the container, and close
tightly.
4 Shake the container to mix engine oil
and gasoline well.
5 Pour the fuel into fuel tank.
ENON00922-1
Notes
z It is recommended to pre-mix by using
separate fuel container. Avoid mixing
the oil and gasoline in the built in fuel
tank on the boat.
z If mixing in built-in fuel tank on the
boat, allow it to mix well by pouring
engine oil into the tank little by little
while pouring gasoline into the tank.
ENOM01661-0
Auto mixing type
ENOW00604-0
z In the unlikely event that gasoline by mis-
take is filled into the oil tank, drain the oil
tank completely, and consult an autho-
rized service shop for advice.
z Check the amount of oil in the oil tank
visually before starting the engine. Run-
ning out of oil at sea is a cause for poten-
tial disaster.
The required amount of engine oil is
automatically supplied from the oil tank,
through the oil pump, according to the
engine running conditions. Gasoline is fed
over a separate feeding line.
 During break-in
Add engine oil into fuel tank. The mixing
ratio with gasoline during break-in is 50:1
Make sure that gasoline and oil are mixed
well.
ENOM00644-1
Replenishing oil in the engine oil tank.
1. Open the filler lid from the top cowl.
2. Open the oil tank cap.
3. Fill the oil tank with the genuine
engine oil.
4. After replenishment of the oil tank, be
sure to close the oil tank cap tightly.
1. Genuine of recommended engine oil
2. Filler lid
3. Oil tank cap
CAUTION
Gasoline : Engine Oil
During break-in 50 : 1
ENOF01963-0
1
3
2