INSPECTION AND MAINTENANCE72
10
ENON00934-1
Note
Dispose used oil according to the local
regulation. For oil disposal, we suggest take
it into local service station in a sealed con-
tainer. Do not throw the used oil in trash,
pour it on the ground or down a drain.
1. Tilt down the outboard motor.
2. Remove the oil plugs (lower and
upper), and completely drain the gear
oil into a pan.
3. Insert the oil tube nozzle into the
lower oil plug hole and fill with gear oil
by squeezing the oil tube until oil
flows out of the upper plug hole. Make
sure that no bubbles are coming out
of the upper plug hole and there is no
air inside the gear case.
ENON00033-1
Note
Use genuine gear oil or ones recom-
mended (API GL-5: SAE #80 to #90).
Required volume: approx. :500mL(16.9
fl.oz)
4. Install the upper oil plug, and then
remove oil tube nozzle and install the
lower oil plug.
Oil plug specified tightening torque
4N·m (3 ft
·lb, 0.4 kgf·m)
ENOW00095-0
Do not reuse oil plug gasket. Always use new
gasket and tighten oil plug properly to pre-
vent entry of water into lower unit.
CAUTION
ENOF01333-0
ENOF01331-0
To Next Page
Loading...
