MAINTENANCE & LUBRICATION
100
Storing Your TOMCAR
®
If your vehicle is to be placed in extended or off-season storage, the following steps should be taken to preserve its condition:
1.
Perform all necessary repairs and thoroughly clean the vehicle.
2.
Remove the spark plug and pour approximately one ounce of synthetic 20W-50 type of oil into the cylinder. Operate the starter for a
few seconds and reinstall the spark plug.
3.
Remove the battery. Store it in a cool, dry place out of the sun.
4.
Raise the vehicle so all tires are suspended off the ground.
5.
Spray oil on all unpainted metal surfaces to prevent rusting. Avoid getting oil on rubber parts or in the brakes.
6.
Lubricate all cables.
7.
Tie a plastic bag over the exhaust pipe and air cleaner inlet to prevent moisture or small animals from entering.
8.
Cover the vehicle with a canvas cover. Do not use plastic or coated materials, since they do not allow ventilation for the vehicle.
Remove Your TOMCAR
®
From Storage
•
Check the battery electrolyte level and charge the battery if necessary. Install it in the vehicle.
•
Make sure the spark plug is tight.
•
Fill the fuel tank with fuel.
•
Perform a Pre-Ride Inspection, as described in this manual (see pgs. 47-48)
•
Lubricate at the intervals outlined in the Periodic Maintenance Chart (see pg. 62).
NOTE:
•
Tightness of the bolts, nuts and other fasteners should be checked by TOMCAR
®
qualiedpersonnel.
•
Engine exhaust fumes contain poisonous carbon monoxide, which can cause serious illness and death. Never run the engine in an
enclosed area such as a closed building without proper ventilation. To ventilate, connect a pipe extension to the exhaust pipe and
discharge the exhaust outdoors. Allow fresh air into the work area.
Cleaning & Storing
100
To Next Page
Loading...