TOMCAR TM2 - Seat Belts

To Next Page

To Previous Page

FEATURES & CONTROLS

Seat Belts

The TOMCAR

is equipped with either a lap belt or a 4-point safety harness.

To replace the lap belt with a 4-point harness, remove the lap belt by unhooking the lap belt clips

located below the left and right side of the seat.

To install the 4-point harness, secure the clips for the left and right lower straps of the harness to the

seat belt brackets. Place the left and right shoulder harness over the seat. Cross the shoulder straps

behind the seat and secure the clips to the shoulder harness brackets.

For your safety, when using the 4-point harness, please perform the following steps:

Loosen shoulder straps. (1)

Place arms through the shoulder straps. (1)

Insert the latch plate into the buckle until it clicks. (3)

Tighten straps (2) followed by shoulder straps (1).

Make sure the harness is tightened securely.

Falling from a moving vehicle could result in serious injury or death. Always fasten your harness

securely before operating or riding in the TOMCAR

Small passengers require special restraints, which are not available with this vehicle. No passenger

should be allowed to ride in the TOMCAR

if the harness does not t properly or if the passenger is

under ve years of age.

To unfasten, press the square red button in the buckle’s center.

Seat Belts