OPERATIONS
Pre-Ride Inspection
47
Pre-Ride Inspection
OPERATIONS
Item Remarks
1. Brake System Check the level of the brake uid in the reservoir canister. Check the completeness of the reservoir
canister and that the cap is tightened.
Verify that the clear tubes coming from the canister to the pump are not damaged in any way.
Pay attention! If brake uid is missing in the canister, that means leakage. Adding brake uid will
not solve the problem!
When pressing the brake pedal, make sure that the pedal feels stiff high up on its travel.
Check that all the hoses coming from the brake pump to the wheels are undamaged and in order
(no leaks).
2. Steering System Check for free play by turning the steering wheel left and right.
3. Air Filter Check that the front air lter is clean.
4. Electrical System Check the light system – front/rear parking lights, headlights high/low, indicators left/right, brake
lights and registration plate light. Check indicator lights on the dashboard (yellow/blue/red).
5. Throttle Travel Check that the throttle has full movement and springs back when released.
6. Front Wheel Check for free play by grabbing the top of the tire rmly and pulling it back and forth.
7. Front Suspension Check shock absorbers by pressing the vehicle hard downward. The vehicle should spring back
slowly and symmetrically.
Check that all fasteners are in place and tight.
Check for free play and adjust ball joint when necessary.
8. Front Wheel Nuts Check that the four-wheel and center wheel nuts are tightened securely.
9. Front Tires Check the condition and ination of the front tires.
10. Moving Parts Under Hood Make sure that there are no loose objects under the hood that might damage or interfere with the
pedals or battery.
Check that the battery is connected and tightened rmly in its place. Make sure that there are no
metal parts that could short the battery.
47
To Next Page
Loading...