䕔
5-8
5.4.3 Maintenance of main unit
䕔
Do not use organic solvents such as thinner to
clean the main unit of the instrument. These
solvents may damage the surface of the
instrument.
䕔
When disconnecting cords, do not apply
excessive force on the cord; for example, do not
hold and pull the cord to disconnect it.
䕔
Do not touch the connection terminal surface of
the main unit or measurement probe.
䖃 Wipe off dirt on the main unit by lightly rubbing with a well wrung
cloth dampened with water and then with a dry cloth. When it is very
dirty, clean it by lightly rubbing with a well wrung cloth dampened
with diluted neutral detergent. Then, wipe it with a cloth dampened
with water and then with a dry cloth.
䖃 Wipe off dirt on the monitor screen with a dry cloth. When it is very
dirty, clean it by lightly rubbing with a well wrung cloth dampened
with diluted neutral detergent. Then, wipe it with a cloth dampened
with water and then with a dry cloth.
䕔
Do not leave any water, chemicals, etc.
remaining on the touch panel as the surface of
the touch panel is vulnerable to moisture. The
surface of the touch panel may be damaged and
unable to maintain the appropriate performance.
● Wipe off dirt on the surface of the touch panel with a dry soft cloth.
When it is very dirty, lightly wipe it with a soft cloth dampened with
alcohol. Further, wipe it with a dry soft cloth to completely remove
moisture.
To Next Page
Loading...
Need help?
General
