@
ToolkitRC
2019
System settings
After selecting the [Settings] function on the main
interface. press the [OK] key to enter the function
display the following interface. Press [up] or [down]
to switch to the second interface. as shown below
Function Description:
Minimum input voltage: Below this voltage. the
device will stop the main port output.
Maximum input power: The maximum power
obtained from the input port during charging.
Safe operating temperature: above this temperature
value. the device will stop the main port output
Safe charging time: The maximum time for
continuous charging and discharging. will stop
working if it exceeds
Discharge mode: Can be set to normal discharge.
discharged by internal heat dissipation. Or recycle
the discharge and recover the energy to the input
To Next Page
Loading...
