@ToolkiRC 2024
The charger supports 2 discharge modes.
1. Normal mode: discharge using internal heat
dissipation, maximum 3.0A@15W discharge.
2. Recycle mode: when a battery is used as the
input, the power is recovered to the input side battery
through this function, max 15.0A@300W discharge.
5. Max input voltage
When the discharge mode is selected to recycle
(Need set ”power type” to Battery, under input setting
firstly) the Max input voltage option will appear. Move
the cursor to [Max Input Vol.] and press [●button] to
adjust. If the input voltage reaches this voltage value
during discharge, the discharge will stop. As shown
below:
To Next Page
