@ToolkiRC 2024
3. Signal output
Move the cursor to Signal Output, short press [●
button] to enter the Signal Output interface
Press [▲▼button] to select the type of signal to be
tested. Choose PWM.
Press the [▲▼button], move the cursor to [Manual],
press [●button] to set the output mode, which can be
set to manual, auto 1, auto 2, and auto 3.
In manual mode, you can change pulse width and
cycle values by using the cursor.
When set to auto 1, 2, 3, the pulse width value of
To Next Page
