ToolKitRC M6AC - Quick Start

@ToolkiRC 2024
8
Quick start
1，Connect a 7-28V or AC 100-240V power supply or
Battery/Power Bank to the input port on the back of the
M6AC.
2，The display shows the boot logo and stays for 2
seconds.
3，A welcome sound (voice pack dependent) is played
simultaneously.
4，After booting up, the screen enters the main
interface as shown below:
5，Press and hold [
■button] can enter into the
Multi-function interface.
6，Press [
▲▼button] to switch between pages.
7，When the charger idle, short press [●button] to set
the charging parameters. Press [
●button] during the
charging process to adjust the amperage or stop the
charge process.
8，When the charger idle, Press and hold [
●button] to
enter the system setting interface.
9，Short press [■button] or return to the previous
interface.