@ToolkiRC 2024
4. ESC test
Select ESC test with the cursor, press [●button] to
enter the ESC test mode, press [▲▼button], move the
cursor to pulse width/ cycle, press [●button] to change
the corresponding value. As shown below:
5. Power
Select the adjustable power supply with the cursor,
and short press [●button] to enter.
The voltage and current of the output power
supply can be set at will. Move the cursor to start, short
press [●button] to start power output and return to the
main interface. As shown below:
To Next Page
