@ToolkitRC 2024
Other functions
1. Firmware upgrade
After connecting the M8D to the computer with the USB
data cable in the box, the computer will recognize a USB
drive named Toolkit. Download the upgrade file
app.upga on the official website. To update copy and
past the new file and overwrite the files in the USB to
upgrade the firmware.
2. Automatically continue charging
When a battery is fully charged, after unplugging the
battery, connect to the next battery, the device will
automatically continue to charge, you can start and stop
this function in the settings menu.
3. Fan stepless speed regulation
When the internal temperature of the device exceeds
43°C ， the fan will increase the fan speed linearly
according to the internal temperature increase or power
increase. Make it less noisy when operating at low
temperatures or low power.
4, USB fast charging
M8D built-in USB fast charging protocol, up to C port up
to 65W charging power, supported protocols are PD, QC,
AFC, FCP, SCP, PE, SFCP, VOC.
5. Manually calibrate voltage
In the system settings, you can access the manual
voltage calibration function. Use a voltmeter to measure
the actual voltage of each battery, move the cursor to
the corresponding voltage value, and modify the
voltage value to be consistent with the voltmeter value
To Next Page
