0-9
0-9
0-9
0-9
：
Valid in the Ed Prog(Edit program) state or Pars Set(Parameters settings) state.
（
0
、
1
、
2
、
3
、
4
、
5
、
6
、
7
、
8
、
9
）
1-3
1-3
1-3
1-3
：
In the Man Op(Manual operation) state, long press 1 key for three seconds, you
can modify the X-axis coordinate to "X-axis mechanical reference point value",
which is set in the Sys Pars(System parameters) area of Pars Set (Parameters
settings) area. In the Man Op(Manual operation) state, long press 2 key for
three seconds, you can modify the Y-axis coordinate to "Y -axis mechanical
reference point value", which is set in the Sys Pars(System parameters) area of
Pars Set (Parameters settings) area. In the Man Op(Manual operation) state,
long press 3 key for three seconds, you can modify the Z-axis coordinate to
"Z-axis mechanical reference point value", which is set in the Sys Pars(System
parameters) area of Pars Set (Parameters settings) area. The three values
defaults are 0.
“
“
“
“ -
-
-
- ”
”
”
”
：
In the Ed Prog(Edit program) state, it is used to distinguish between movement
direction. In the Man Op(Manual operation) state, it is used to operate the
Z-axis reverse rotation.
“
“
“
“ .
.
.
. ”
”
”
”
：
In the Ed Prog(Edit program) state, it is used to distinguish between numerical
accuracy. In the Man Op(Manual operation) state, it is used to operate the
Z-axis forward rotation.
Exit
Exit
Exit
Exit : Invalid in the program running process and valid in the rest of the state. It is
used to return to previous operation interface.
“←”
“←”
“←”
“←”
：
In the Man Op(Manual operation) state, X-axis is reverse rotation. It is valid in
To Next Page
Loading...
Need help?
General
