Topcnc TC5510 User Manual

the ProgMgmt(Program management) state or Pars Set(Parameters settings)
state and used to move the cursor.
“→”
“→”
“→”
“→”
：
In the Man Op(Manual operation) state, X-axis is forward rotation. It is valid in
the ProgMgmt(Program management) state or Pars Set(Parameters settings)
state and used to move the cursor.
“↑”
“↑”
“↑”
“↑”
：
In the Man Op(Manual operation) state, Y -axis is forward rotation. It is valid in
the ProgMgmt(Program management) state or Pars Set(Parameters settings)
state and used to move the cursor.
“↓”
“↓”
“↓”
“↓”
：
In the Man Op(Manual operation) state, Y-axis is reverse rotation. It is valid in
the ProgMgmt(Program management) state or Pars Set(Parameters settings)
state and used to move the cursor.
PgUp
PgUp
PgUp
PgUp : PageUp. In the main interface, AutoExec(Automatically execute) or Man
Op(Manual operation) state
，
it is the rate+ key of the speed F value and used to
increase rate of the current speed F value, maximum to 150%. In the
ProgMgmt(Program management) state or Pars Set(Parameters settings) state,
it is used to page up the current page.
PgDn
PgDn
PgDn
PgDn : PageDown. In the main interface, AutoExec(Automatically execute) or Man
Op(Manual operation) state
，
it is the rate- key of the speed F value and used to
reduce rate of the current speed F value, minimum to 10%. In the
ProgMgmt(Program management) state or Pars Set(Parameters settings) state,
it is used to page down the current page.
Cfm:
Cfm:
Cfm:
Cfm: Confirm. Valid in the Pars Set(Parameters settings) state. When modifying

Topcnc TC5510 Specifications

General

Brand	Topcnc
Model	TC5510
Category	Controller
Language	English