Topcon IS01 - Power Source and Charging; On-Board Battery BT-65 Q

141
11 POWER SOURCE AND CHARGING
11 POWER SOURCE AND CHARGING
11.1 On-board Battery BT-65Q
• To remove
1
Pull the battery cover lever and open the cover.
2
Remove the battery.
• To charge
1
Connect the AC-Cable to the charger. *1)
2
Plug the AC-Plug into the outlet. (The POWER LED will light.)
3
Attach the battery in the charger. Charging will start. (The CHARGE LED will light.)
Charging will take approximately 5 hours. (The CHARGE LED will go out.)
If battery power is at a very low level when beginning charging, such as after the instrument has
been in storage over an extended period of time in a discharge state, a full charge may not be
possible with a single charging. In such a case, recharge a second time.
4
After charging, remove the battery from the charger.
Remove the charger from the outlet.
The POWER LED
Red ON : Power is on.
The CHARGE LED will indicate charging status;
On Solid : Wait for charging.
Red ON : Charging.
On Solid : Charging completed.
Red Flashing: Charging error.
CHARGE LED will flash when the battery life is over or the battery is
broken down. Replace the battery to new one.
• To install
1
Place the battery to the instrument.
2
Shut the battery cover until click sound can be heard.
BC-30
AC-cable
Battery cover lever
Battery
POWER LED
CHARGE LED
BT-65Q