Topcon IS01 - Setting Tilt Correction by Operation Key; Correction of a Tilt Sensor Setting Error

49
2 PREPARATION FOR MEASUREMENT
2.5.1 Setting Tilt Correction by Operation Key
[Example] Setting Tilt OFF
• The setting performed here will be interlocked with setting in Chapter 6 “PARAMETERS SETTING
MODE”
2.5.2 Correction of a Tilt Sensor setting error
An error in setting up the Tilt Sensor can be automatically corrected with the Self Checking function.
See Chapter 7.6 “Self Checking Mode” .
1
Press the [P1] key to get the page 2.
2
Press the [TILT] key.
Current setting is displayed.
3
Press [OFF] key.
4
Press [EXIT] key.
The display returns previous mode.