7- MAINTENANCE
7.1-
IF THE ACTUATOR WORKS INCORRECTLY, CONTACT THE MANUFACTURER.
ANY WORK ON THE ACTUATOR (E.G.: POWER CABLE, ETC.) OR ITS COMPONENTS MAY
ONLY BE CARRIED OUT BY PERSONNEL QUALIFIED BY THE MANUFACTURER.
TOPP DECLINES ALL LIABILITY FOR WORK PERFORMED BY UNAUTHORISED PEOPLE.
The actuator incorporates components that do not require significant routine or
extraordinary maintenance operations.
In heavy-duty conditions (e.g.: very dirty work areas, frequent use, elevated
temperature changes, load variations caused by wind or snow, etc.) make sure, at least
once every 6 months, that the actuator assembly components are clean, the fixing
systems (brackets and screws) are tight, the window frame is not deformed and the
seals are tight, and check the cables and connectors.
If any malfunctions arise after cleaning or inspection, contact the TOPP technical
assistance service.
GENERAL INSTRUCTIONS
8.1- GENERAL INSTRUCTIONS
THE DEMOLITION OF THE ACTUATOR MUST OCCUR IN COMPLIANCE WITH THE LAWS
IN FORCE ON ENVIRONMENT PROTECTION.
DIFFERENTIATE THE PARTS MAKING UP THE ACTUATOR ACCORDING TO THEIR
DIFFERENT MATERIAL TYPE (PLASTIC, ALUMINIUM, ETC.).
8- DEMOLITION
C20
C20
28
VER.0.0
REV.09.13
INSTALLATION AND USE ISTRUCTIONS
To Next Page
Loading...
Need help?
General
