12
RECOVERY TANK
Check that the cover of the suction filter (1)
is correctly secured, after rotating the levers
and that the suction motor hose (2) is correctly
connected. Verify also that the squeegee hose
is correctly inserted into the seats (3 and 4) and
that the exhaust hose plug (5) placed in the
front part of the machine, is closed.
DETERGENT SOLUTION TANK
The solution tank is provided with an inspection
opening. This permits cleaning of the detergent
solution. Be sure that the cap is well tightened
after the cleaning.
The capacity of the detergent solution tank
is indicated in the technical data. Open the
screw plug (1) placed in the rear left part of the
machine and fill the detergent solution tank
with clean water at a maximum temperature of
122°F (50°C).
Always use low foam detergent. To avoid foam
presence, before starting working operation,
introduce into the recovery tank a minimum
quantity of anti-foam product. Never use pure
acid.
FLOOR CLEANING
CONNECTION OF THE BATTERIES TO THE
MACHINE
Plug in the batteries connector (1) to the
machine connector (2), placed in the rear part
of the machine
Add the liquid detergent in the percentage and
conditions recommended by the manufacturer.
To avoid excessive foam presence, which could
cause problems to the suction motor, use the
minimum percentage of detergent. Screw down
the plug to close the tank.