19
EXCESSIVE FOAM PRODUCTION
Check that low foam detergent has been used.
Eventually add small quantities of anti foam
liquid into the recovery tank. Please be aware
that a bigger quantity of foam is produced
when the floor is not very dirty. In this case
please dilute detergent solution.
THE SQUEEGEE DOES NOT DRY PERFECTLY
1. Check that the squeegee rubbers are clean.
2. Check the height and inclination of the
squeegee (see under “SQUEEGEE” in
“BEFORE USE”).
3. Check that the suction hose is correctly
inserted in the proper seat on the recovery
tank.
4. Clean the suction filter.
5. Replace the rubbers if worn out.
6. Check that the suction motor switch is on.
7. Check that the recovery tank is empty.
DAILY WEEKLY Bi-MONTHLY SIX-MONTH
RECOVERY TANK CLEANING X
SUCTION FILTER CLEANING X
SOLUTION TANK FILTER CLEANING X
BRUSHES CLEANING X
BRUSHES DISASSEMBLY X
SQUEEGEE CLEANING X
FRONT SQUEEGEE RUBBER REPLACEMENT X
REAR SQUEEGEE RUBBER REPLACEMENT X
SQUEEGEE ADJUSTMENT CHECK X
SQUEEGEE HOSE CLEANING X
SOLUTION TANK CLEANING X
BATTERIES ELECTROLYTE CHECK X
BRUSHES MOTOR CHECK X
SUCTION MOTOR CHECK X
BRUSHES BASE GROUP CHECK X
SCREW TIGHTENING X
PROGRAMMED MAINTENANCE
To Next Page
Loading...
Need help?
General