Glow Plug Indicator Light
W hen lit, the glo w plug indicator light ( Figure 2 )
indicates that the glo w plugs are on.
Engine Temperature Gauge
T his g aug e ( Figure 2 ) indicates the engine coolant
temperature .
Speed Limiter
Adjust the screw ( Figure 3 ) to limit the amount
the traction pedal can be de pressed in the forw ard
direction to limit speed.
Important: T he traction pedal must contact
the speed limiter bef or e r eaching the end of
the pump str ok e to pr ev ent pump dama ge.
Figure 3
1. Speed limiter
Lift Levers
T he lift lev ers ( Figure 4 ) raise and lo w er the cutting
units .
Important: T he center lift lev er must
momentaril y be pushed to the lo w er position
to ena ble PT O circuit actuation by PT O
s witch.
Cutting Unit Service Lock
T he cutting unit ser vice loc k ( Figure 4 ) loc ks the
front cutting unit lift lev er when the cutting unit
is in the raised position.
Key Switch
T he k ey switc h ( Figure 4 ) has three positions: Off ,
On/Preheat, and Star t.
PTO Switch
T he PTO switc h ( Figure 4 ) has three positions: On
(eng ag e), Neutral, and Off (diseng ag e). Carefully
lift and push the PTO switc h forw ard to the On
position to star t the implement or cutting unit
blades . Slo wly pull the switc h bac kw ard to the Off
position to stop implement operation.
Important: T he center lift lev er must
momentaril y be pushed to the lo w er position
to ena ble PT O circuit actuation by PT O
s witch.
Hi-Lo Speed Control
T he control ( Figure 4 ) allo ws the speed rang e to
increase for transpor t of the mac hine .
Figure 4
1. Lift lever 8. Temperature reset switch
2. Front cutting unit service
lock
9. Hour meter
3. Key switch 10. Fuel gauge
4. PTO switch 11. Throttle
5. Hi-lo speed control 12. Audible alarm
6. Cruise control (optional)
13. Power point
7. Alarm silence switch
Cruise Control (Optional)
T he cr uise control ( Figure 4 ) sets the speed of the
mac hine .
Fuel Gauge
T he fuel g aug e ( Figure 4 ) indicates the lev el of fuel
in the tank.
17
To Next Page
Loading...
