EasyManua.ls Logo

Toro 30411 - Maintenance; Recommended Maintenance; Schedule(S)

Toro 30411
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance
Note: Deter mine the left and right sides of the mac hine from the nor mal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the rst 10
operating hours
Torque the wheel lug nuts.
Check the fan and alternator belt tension.
Check the blade drive belt tension.
After the rst 50
operating hours
Change the engine oil and lter.
Check the engine RPM (at idle and full throttle).
Torque the locknuts on the pivots.
After the rst 200
operating hours
Change the front planetary gear oil.
Change the rear axle oil.
Change the hydraulic oil.
Change the hydraulic oil lters.
Before each use or daily
Check the engine oil level.
Check the coolant level.
Check the hydraulic uid level.
Check the tire pressure.
Every 50 hours
Lubricate all grease ttings.
Inspect the air cleaner.
Check the battery level and cable connections.
Check the blade drive belt tension.
Clean the underside of the mower housing and under the belt covers.
Every 100 hours
Inspect the cooling system hoses.
Check the fan and alternator belt tension.
Every 150 hours
Change the engine oil and lter.
Every 200 hours
Torque the wheel lug nuts.
Service the spark arrestor.
Every 400 hours
Check the planetary gear drive oil.
Check the rear axle lubricant.
Check the rear axle gear box lubricant.
Service the air lter (if the indicator shows red).
Inspect the fuel lines and connections.
Change the fuel lters (fuel/water and prelter).
Check the engine RPM (at idle and full throttle).
Every 800 hours
Drain and clean the fuel tank.
Change the front planetary gear oil.
Change the rear axle oil.
Check the rear wheel toe-in.
Inspect the blade drive belts.
Change the hydraulic oil.
Change the hydraulic oil lters.
Inspect the cutting unit castor wheel assemblies.
Check and adjust the valve clearance.
Every 2 years
Replace the safety switches.
Flush the cooling system and replace uid.
Replace moving hoses.
33

Table of Contents

Other manuals for Toro 30411

Related product manuals