Toro 30857N - Cutting Deck Maintenance; Separating the Cutting Decks from the Traction Unit

Note:Themachinecannotbeoperatedwhileinthe
counterbalanceadjustmentmode.Oncetheadjustment
hasbeencompleted,movethemachinetoatestarea
andoperatethemachinewiththenewsetting.The
newcounterbalancedsettingmaychangetheeffective
heightofcut.
CuttingDeck
Maintenance
SeparatingtheCuttingDecks
fromtheTractionUnit
1.Positionthemachineonalevelsurface,lowerthe
cuttingdeckstotheoor,shuttheengineoff,and
engagetheparkingbrake.
2.Disconnectandremovethehydraulicmotorfrom
thedeck(Figure58).Coverthetopofthespindleto
preventcontamination.
Figure58
1.Motormountingscrews
3.Removethelynchpinorretainingnut(GM4700only)
securingthedeckcarrierframetotheliftarmpivot
pin(Figure59).
Figure59
1.Lynchpin
2.Liftarmpivotpin
4.Rollthecuttingdeckawayfromthetractionunit.
44