Toro 30873TE - Checking the Tire Pressure; Checking the Torque of the Wheel Lug Nuts; Adjusting the Height of Cut

CheckingtheTirePressure
ServiceInterval:Beforeeachuseordaily
Thecorrectairpressureinthetiresis138kPa(20psi).
Important:Maintaintherecommendedpressure
inalltirestoensureagoodqualityofcutand
propermachineperformance.Donotunder-inate
thetires.
Checktheairpressureinallthetiresbefore
operatingthemachine.
g001055
Figure18
CheckingtheTorqueofthe
WheelLugNuts
ServiceInterval:Afterthersthour
Aftertherst10hours
Every200hours
Torquethewheellugnutsto115to136N∙m(85to100
ft-lb)intheordershowninFigure19andFigure20.
g033358
Figure19
FrontWheels
g033359
Figure20
RearWheels
WARNING
Failingtomaintainpropertorqueofthewheel
lugnutscouldresultinpersonalinjury.
Torquethewheellugnutstothepropertorque
value.
AdjustingtheHeightofCut
Important:Thecuttingunitsoftencut
approximately6mm(1/4inch)lowerthanareel
cuttingunitwiththesamebenchsetting.It
maybenecessarytosetthecutting-unitbench
measurementat6mm(1/4inch)abovethatofreel
cuttingunitscuttinginthesamearea.
Important:Accesstotherearcuttingunitsis
greatlyimprovedbyremovingthecuttingunit
fromthemachine.
1.Parkthemachineonalevelsurface,engage
theparkingbrake,lowerthecuttingunittothe
ground,shutofftheengine,andremovethekey.
2.Loosentheboltsecuringeachheight-of-cut
brackettotheheight-of-cutplate(frontandeach
side)asshowninFigure21.
3.Beginningwithfrontadjustment,removethe
bolt.
27