Toro 74991 - Page 64

6.Inserttheheight-adjustmentpinintothe7.6cm
(3inch)cutting-heightposition.
7.Releasethetransportlockandallowthedeckto
lowertothecuttingheight.
8.Raisethedischargechute.
9.Onbothsidesofthedeck,measurefromthe
levelsurfacetothefronttipoftheblade(Postion
A).Themeasurementshouldread7.6mm(3
inches);refertoFigure95.
g009196
Figure95
1.7.6cm(3inches)atAis
correct
3.Measureherefromthe
bladetiptohardsurface
2.8.3cm(3-1/4inches)atB
iscorrect
4.MeasureatAandBon
bothsides
10.Ifneeded,loosentheangedlocknutontheside
oftheyokeandthejamnutontop.Fine-tune
theadjusterscrewbyturningittoget7.6mm(3
inch)height(Figure96).
Toincreasetheheight,turntheadjusterscrew
clockwise;todecreasetheheight,turnit
counterclockwise.
g029650
Figure96
1.Flangedlocknut3.Jamnut
2.Adjusterscrew4.Yoke
11.Ifthefrontdecklinksdonothaveenough
adjustmenttoachieveaccuratecutheight,the
singlepointadjustmentcanbeutilizedtogain
moreadjustment.
12.Toadjustthesinglepointsystem,loosenthetwo
boltsatthebottomoftheheight-of-cutplate.
RefertoFigure97.
g029651
Figure97
1.Boltsatthebottomoftheheight-of-cutplate
13.Ifthedeckistoolow,tightenthesinglepoint
adjustmentboltbyrotatingitclockwise.If
thedeckistoohigh,loosenthesinglepoint
adjustmentboltbyrotatingitcounterclockwise
(Figure98).
Note:Loosenortightenthesinglepoint
adjustmentboltenoughtomovethe
height-of-cutplatemountingboltsatleast1/3
thelengthoftheavailabletravelintheirslots.
64