15
The ECx program memory can be reset to the perma-
nent program values or cleared completely at any time
without removing power.
Resetting the permanent program erases all user input
and replaces it with the permanent program values.
Clearing the program memory sets all program values to
Off (i.e., no active days, program start times or zone run
times). You may find that this simplifies programming the
timer if your watering requirements are quite different
than the permanent values.
Note: When power is first applied, the ECx will always
reset to the permanent program values.
To Reset The Permanent Program (Figure 3)
Turn the control dial to the OFF position. OFF will be
displayed.
Press the +/ON and –/OFF buttons at the same time
until CLR is displayed.
Return the control dial to the
AUTO/ON position.
To Clear The Memory (Figure 4)
Turn the control dial to the OFF position. OFF will be
displayed.
Press the +/ON and –/OFF buttons at the same time
until CLR 0 is displayed.
Return the control dial to the
AUTO/ON position.
To Next Page
Loading...
