Toro ECx - Connecting The Valves

Turn the control dial to the SET ZONE RUN TIMES
position.
Check the
PROGRAMS switch setting. If necessary,
reposition the switch to select the desired program.
Zone number 1 will be flashing and its current run
time or OFF will be shown. To select a different zone
number, press the
+/ON or the –/OFF button until the
desired zone number is flashing.
Press the
NEXT button. The run time (or OFF) will
begin flashing.
To set the run time, press the
+/ON or the –/OFF but-
ton until the desired run time is shown.
Note: To remove the run time, select OFF by press-
ing the
+/ON and –/OFF buttons at the same time.
Press the NEXT button. The next zone number will
begin flashing.
7. Repeat steps and as needed to set, change,
or remove the run time for the remaining zones
.
8. To set the zone run time for another program, repeat
all of the steps starting at step .
Return the control dial to the
AUTO/ON position.
9
2
65
6
5
4
3
2
1
Setting Zone Run Times
21
PGM A
123456
3 5
3 5
6
9
4
3
5
2
1
4
2
MANUAL
START
AUTO / ON
SET TIME / DAY
SET ZONE
RUN TIMES
SEASON
ADJUST
OFF
RAIN
DELAY
SET
WATERING
DAYS
SET
PROGRAM
START
TIMES
ON
NEXT
OFF
PROGRAMS