Toro ECx User Manual

Turn the control dial to the SET PROGRAM START
TIMES
position.
Check the
PROGRAMS switch setting. If necessary,
reposition the switch to select the desired program.
Program start time number 1 will begin flashing. The
current program start time or OFF will be displayed
for start time number 1. To select a different program
start time number, press the
+/ON or the –/OFF button
until the desired number is flashing.
Press the
NEXT button. The hour digit(s) or OFF will
begin flashing.
Note: To remove the start time, select OFF by
pressing the
+/ON and –/OFF buttons at the same
time
, and continue at step .
To set the hour (and
AM/PM), press the +/ON or the
–/OFF button until the desired hour is flashing.
Press the
NEXT button. The minute digits will begin
flashing.
To set the minutes, press the
+/ON or –/OFF button
until the desired minute is flashing.
Press the
NEXT button. The next program start time
number will begin flashing.
To select another start time number, press the
+/ON
or the –/OFF button until the desired start time num-
ber is flashing.
10. To set, change or remove a program start time for
the start time number selected, repeat all of the
steps starting at step .
11. To set program start times for another program,
repeat all of the steps starting at step .
Return the control dial to the
AUTO/ON position.
12
2
4
9
8
7
6
5
8
4
3
2
1
Setting Program Start Times
20
PGM A
AM
12
12
1
4
6
8
3 57
3
4 5 6 7
75
9
2
3
9
9
2
MANUAL
START
AUTO / ON
SET TIME / DAY
SET ZONE
RUN TIMES
SEASON
ADJUST
OFF
RAIN
DELAY
SET
WATERING
DAYS
SET
PROGRAM
START
TIMES
ON
NEXT
OFF
PROGRAMS

Toro ECx Specifications

General

Display	LCD
Weather Sensor Compatibility	Yes
Zones	Up to 12
Programming	Digital
Watering Schedule	Flexible