Greensmaster Flex 1800/1820/2100/2120Page 6 − 8Chassis and Controls
Traction Clutch Cable Replacement
1. Brake cable
2. Brake lever
3. Lever assembly
4. Shift mount
5. Reel clutch cable
6. Console cover
7. Washer head screw (4 used)
8. Lower handle
9. Traction switch
10. Traction clutch cable
11. Shifter bracket
Figure 8
RIGHT
FRONT
1
4
7
8
9
10
2
5
3
6
11
Note orientation
of spring hook
Removal
1. Park machine on a level surface. Make sure the en-
gine is OFF and the traction lever is in NEUTRAL.
2. Remove traction clutch cable from the transmission
(Fig. 9):
A. Loosen front cable jam nut that secures cable to
traction cable bracket on transmission. Lift cable
from bracket.
B. Remove flange nut that secures cable eyelet to
transmission bellcrank lever and slide cable eyelet
from lever.
3. Remove console cover from handle assembly to al-
low access to upper end of traction clutch cable.
4. Remove traction clutch cable from the traction lever
assembly (Fig. 10):
A. Loosen lower cable jam nut that secures traction
clutch cable to shift mount bracket on handle. Slide
cable from bracket.
B. Remove cable spring from spring anchor on lever
assembly. Note orientation of cable spring hook on
lever assembly for assembly purposes.
5. Remove traction clutch cable from machine.
To Next Page
Loading...
