Greensmaster Flex 1800/1820/2100/2120Page 7 − 12Cutting Unit
Bedbar Assembly
1. Bedbar
2. Bedknife
3. Screw (13 used)
4. Bedbar adjuster screw (2 used)
5. Bedbar adjuster shaft (2 used)
6. Cap screw (2 used)
7. Detent (2 used)
8. Wave washer (2 used)
9. Retaining ring (2 used)
10. Lock nut (2 used)
11. Washer (2 used)
12. Compression spring (2 used)
13. Lock nut (2 used)
14. Rubber bushing (2 used)
15. Nylon bushing (2 used)
16. Plastic washer (4 used)
17. Metal washer (4 used)
18. Bedbar pivot bolt (2 used)
Figure 18
FRONT
RIGHT
200 to 250 in−lb
(23 to 28 N−m)
Antiseize
Lubricant
1
17
16
18
10
14
15
16
17
7
4
13
6
11
12
8
9
2
3
5
190 to 240 in−lb
(22 to 27 N−m)
Flex 2100/2120 Shown
Bedbar Removal (Fig. 18)
1. Park machine on a level surface. Make sure the en-
gine is OFF and the traction lever is in NEUTRAL.
2. Remove the cutting unit from the machine and place
cutting unit on a flat work area.
3. Tip the cutting unit to expose the bedknife. Support
the rear of the cutting unit (see Supporting Cutting Unit
when Servicing in the General Information section of
this chapter).
4. Loosen the lock nuts (item 13) on the end of each
bedbar adjuster assembly until washer (item 11) is
loose.
5. Loosen the lock nuts (item 10) on each bedbar pivot
bolt (item 18).
6. Remove two (2) bedbar pivot bolts (item 18), four (4)
metal washers (item 17) and four (4) plastic washers
(item 16) from the cutting unit side plates.
To Next Page
Loading...
