EasyManua.ls Logo

Toro Greensmaster Flex 2100 - Special Tools

Toro Greensmaster Flex 2100
198 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Greensmaster Flex 1800/1820/2100/2120Page 5 - 8Electrical System
Special Tools
Order special tools from your Toro Distributor. Some
tools may also be available from a local supplier.
Multimeter
The multimeter can test electrical components and cir-
cuits for current, resistance or voltage.
NOTE: Toro recommends the use of a DIGITAL Volt-
Ohm- Amp multimeter when testing electrical circuits.
The high impedance (internal resistance) of a digital me-
ter in the voltage mode will make sure that excess cur-
rent is not allowed through the meter. This excess
current can cause damage to circuits not designed to
carry it.
Figure 1
Skin- Over Grease
Special non- conductive grease which forms a light pro-
tective skin to help waterproof electrical switches and
contacts.
Toro Part Number: TOR50547
Figure 2
Dielectric Gel
Dielectric gel should be used to prevent corrosion of
connection terminals. To ensure complete coating of ter-
minals, liberally apply gel to both component and wire
harness connector, plug connector to component, un-
plug connector, reapply gel to both surfaces and recon-
nect harness connector to component. Connectors
should be thoroughly packed with gel for effective re-
sults.
Toro Part Number: 107- 0342
Figure 3

Table of Contents

Other manuals for Toro Greensmaster Flex 2100

Related product manuals