Greensmaster Flex 1800/1820/2100/2120Page 6 − 14Chassis and Controls
4. Connect spring (item 11 in Figure 15) between trac-
tion lever assembly and operator presence control.
5. Connect wire harness connector to traction switch
(Fig. 15).
6. Connect reel clutch and traction clutch cables to le-
ver assembly (see Cable Replacement in this section).
Check cable operation and adjust as necessary.
7. Check adjustment of traction switch (see Traction
Switch in the Adjustments section of Chapter 5 − Electri-
cal System). Adjust switch if necessary.
8. Install console cover to handle.
1. Transport lever
2. Reel shaft lever
3. Clearance location
4. Shifter bracket
5. Screw and nut
Figure 17
1
2
3
5
5
4
To Next Page
Loading...
