Greensmaster Flex 1800/1820/2100/2120 Page 7 − 9 Cutting Unit
Factor Possible Problem/Correction
Rear roller level. Reel and rear roller should be parallel for proper
cutting performance (see Leveling Rear Roller in
Adjustments section of this chapter).
Roller condition. Make sure rollers rotate freely. Repair roller bearings if
necessary (see Roller Service in Service and Repairs
section of this chapter).
Traction speed. Check maximum governed engine speed. Adjust
engine to specifications if necessary (see Adjustments
section in Chapter 3 − Engine).
The traction drive belt may be loose or worn. Check
the condition of the traction belt. Replace traction drive
belt if necessary.
Groomer reel operation. See Troubleshooting section of Chapter 8 − Groomer.
Cutting Unit
To Next Page
Loading...
