Toro Groundsmaster 4100 - Page 27

decal106-4251nc
Figure20
Note:Whenusing25mm(1inch),38mm
(1-1/2inch),oroccasionally51mm(2inch)
height-of-cut,movetheskidsandgagewheels
tothehighestposition.
WingMowerDecks
Toadjusttheheightofcutonthewingmowerdecks,
addorremoveanequalnumberofspacersfromthe
casterforks,positionthecaster-wheelaxlesinthe
highorlowheight-of-cutholesinthecasterforks,and
securethepivotarmstotheselectedheight-of-cut
bracketholes.
1.Positionthecaster-wheelaxlesinthesame
holesinallofthecasterforks(Figure21and
Figure23).
2.Removethetensioningcapfromthespindle
shaftandslidethespindleoutofthecasterarm
(Figure21).
g008866
Figure21
1.Tensioningcap4.Topaxle-mountinghole
2.Spacers5.Casterwheel
3.Shims
3.Install2shimsontothespindleshaftasthey
wereoriginallyinstalled.
Note:Theseshimsarerequiredtoachievea
levelacrosstheentirewidthofthemowerdecks.
Slidetheappropriatenumberof13mm(1/2
inch)spacers(refertothechartbelow)ontothe
spindleshafttoattainthedesiredheight-of-cut,
thenslidethewasherontotheshaft.
Refertothefollowingcharttodeterminethe
combinationsofspacersforthesetting(Figure
22).
decal100-5622nc
Figure22
4.Pushthecasterspindlethroughthefrontcaster
arm.
5.Installtheshims(astheywereoriginally
installed)andtheremainingspacersontothe
spindleshaft.
6.Removethehairpincotterandclevispinsfrom
thecaster-pivotarms(Figure23).
7.Rotatethetensionrodtoraiseorlowerthepivot
armuntiltheholesarealignedwiththeselected
height-of-cutbracketholesinthemower-deck
frame(Figure23andFigure24).
g004676
Figure23
1.Caster-pivotarm3.Clevispinandhairpin
cotter
2.Axle-mountingholes4.Tensionrod
27