Front Traction Motor Repairs (Fig. 24)
Figure 24
1. Valve plate 7. Sleeve 13. Straight
2. Cylinder block kit 8. Roller bearing 14. End cap assembly
3. Shaft assembly 9. Housing 15. Flat washer
4. Plug 10. Thrust plate 16. Capscrew
5. O-ring seal 11. Gasket 17. Retaining ring
6. Lip seal 12. Bearing
Shaft Seal Replacement Prior to installing the new seal, polish the shaft exten-
sion, wrap it in thin plastic and lubricate with hydraulic
The lip type shaft seal (Item 6) can be replaced without oil to in
sure that the seal is not damaged during assem-
disassembly of the motor; however, replacement of the bly. Slide the seal over the shaft and press it into the
seal requires removal of the motor from the transaxle. housing bore.
Pry the seal carefully out of the housing bore, using care
no
t to distort the housing or damage the bore or shaft.
Once removed, the seal is not reusable.
Repairs Pa
ge 4 - 40 Groundsmaster
®
455-D
To Next Page
Loading...
